Toptech Systems MultiLoad II User Manual

Chapter 4 – General Configuration
72
Firmware Version 3/4.31.37
4.3.3 TERMSERVER SETUP
Parameter
Description
Com0 Port(7000)
This parameter can be configured to allow external communication from any system via
Ethernet and pipe this data transfer to the serial port.
Protocols supported are Smith, Daniels, Brooks, and Modbus RTU.
Com0 Port(7010)
This parameter can be configured to allow external communication from any system
which understands the SSL TLSv1.2 protocol. So the Ethernet data can be piped to the
serial port.
Protocols supported are Smith, Daniels, Brooks, and Modbus RTU.
Com1 Port(7001)
This parameter can be configured to allow external communication from any system via
Ethernet and pipe this data transfer to the serial port.
Protocols supported are Smith, Daniels, Brooks, and Modbus RTU.
Com1 Port(7011)
This parameter can be configured to allow external communication from any system
which understands the SSL TLSv1.2 protocol. So the Ethernet data can be piped to the
serial port.
Protocols supported are Smith, Daniels, Brooks, and Modbus RTU.
Com2 Port(7002)
This parameter can be configured to allow external communication from any system via
Ethernet and pipe this data transfer to the serial port.
Protocols supported are Smith, Daniels, Brooks, and Modbus RTU.
Com2 Port(7012)
This parameter can be configured to allow external communication from any system
which understands the SSL TLSv1.2 protocol. So the Ethernet data can be piped to the
serial port.
Protocols supported are Smith, Daniels, Brooks, and Modbus RTU.
TERMSERVER SETUP
Com0 Port(7000): ENABLED
Com0 SSL Port(7010): DISABLD
Com1 Port(7001): ENABLED
Com1 SSL Port(7011): DISABLD
Com2 Port(7002): ENABLED
Com2 SSL Port(7012): DISABLD
Next Prev Exit Enter

Toptech Systems MultiLoad II Specifications

General

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English