Toptech Systems MultiLoad II User Manual

Chapter 4 – General Configuration
156
Firmware Version 3/4.31.37
4.16.3 ADDITIVE ASSIGNMENT
After defining your base additives, this function allows assignment to the physical additive.
When selected the Additive Selection Screen is displayed:
Configure the assigned Base Additive as shown in the example below.
4.16.4 SAMPLER ASSIGNMENT
After defining your sampler, this function allows assignment to the physical sampler.
When selected the Sampler Selection Screen is displayed:
PRE #1 (Preset 001) ADDITIVE SELECTION
Adtv #1: AD720 ADSP0720
Next Prev Exit Enter
PRE #1 (Preset 001) ADDITIVE SELECTION
Adtv #1: ADD001 Adtv 001
Next Prev Exit Enter

Toptech Systems MultiLoad II Specifications

General

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English