Toptech Systems MultiLoad II

Chapter 9 – Weights & Measures
286
Firmware Version 3/4.31.37
Table
Description
Table TEC ETH
B40
This table provides CTL factors for correcting volumes of ethanol at observed temperatures
to the volume at either 15 C or 60 F. Use this table if the following conditions exist:
 The liquid is ethanol
 Coefficient of expansion at 15 C or 60 F is not known
 Reference Temperature is 15 C or 60 F (needs to be maintained under component level!)
Coefficient of Density is fixed at 0.84*10E-3
Test temperatures can be entered on this screen that will calculate a CTL based on the test
temperature and coefficient of expansion. The test temperature and Calculated CTL are for
informational purposes and will not be used in calculations during operations.
Note: Blend range from B0 to B40
Table TEC ETH
E40
This table provides CTL factors for correcting volumes of ethanol at observed temperatures
to the volume at either 15 C or 60 F. Use this table if the following conditions exist:
 The liquid is ethanol
 Coefficient of expansion at 15 C or 60 F is not known
 Reference Temperature is 15 C or 60 F (needs to be maintained under component level!)
Coefficient of Density is fixed at 1.27*10E-3
Test temperatures can be entered on this screen that will calculate a CTL based on the test
temperature and coefficient of expansion. The test temperature and Calculated CTL are for
informational purposes and will not be used in calculations during operations.
Note: Blend range from E0 to E40
Table TEC ETH
E100
This table provides CTL factors for correcting volumes of ethanol at observed temperatures
to the volume at either 15 C or 60 F. Use this table if the following conditions exist:
 The liquid is ethanol
 Coefficient of expansion at 15 C or 60 F is not known
 Reference Temperature is 15 C or 60 F (needs to be maintained under component level!)
Coefficient of Density is fixed at 1.14*10E-3
Test temperatures can be entered on this screen that will calculate a CTL based on the test
temperature and coefficient of expansion. The test temperature and Calculated CTL are for
informational purposes and will not be used in calculations during operations.
Note: Blend range from E60 to E100