To Next Page

To Previous Page

Chapter 9 – Weights & Measures

290

Firmware Version 3/4.31.37

Table

Description

ASTM1250-

2004 Table 24D

This table provides CTL factors for correcting volumes of lube oils at observed temperatures

to the volume at 60 F, using the method outlined in Chapter 11.1.6.1 of the 2004 standard.

Use this table if the following conditions exist.

 The liquid is a lube oil

 Relative Density at 60 F is known

 Reference Temperature is 60 F

ASTM1250-

2007 Table 24E

This table provides CTL factors for correcting volumes of light hydrocarbons at observed

temperatures to the volume at 60 F. Use this table if the following conditions exist.

 The liquid is a NGL or LPG (propane)

 Relative Density at 60 F is known

 Reference Temperature is 60 F

After selecting this table, enter the Relative Density of the liquid at 60 F. The valid range of

Relative Density is from 0.3500-0.6880. Test temperatures can be entered on this screen

that will calculate a CTL based on the test temperature and the Relative Density. The test

temperature and Calculated CTL are for informational purposes and will not be used in

calculations during operations.

ASTM1250-

2004 Table 24X

This table provides the CTL factors of a petroleum product at observed temperatures and

Relative Density. This table allows specifying the commodity being measured, the

reference temperature, and units of measure for density, pressure, and temperature

ASTM1250-

2004 Table 23A

This table provides the value of relative density at 60 F of crude oil at observed

temperature and density. Use this table if the following conditions exist:

 The liquid is crude oil.

 Current Temperature and Density is available.

 Relative Density at 60 F is unknown

Reference Temperature is 60 F

ASTM1250-

2004 Table 23B

This table provides the value of relative density at 60 F of gasolines at observed

temperature and density. Use this table if the following conditions exist:

 The liquid is a refined product.

 Current Temperature and Density is available.

 Relative Density at 60 F is unknown

Reference Temperature is 60 F

ASTM1250-

2004 Table 23D

This table provides the value of relative density at 60 F of lubricating oils at observed

temperature and density. Use this table if the following conditions exist:

 The liquid is a lubricating oil.

 Current Temperature and Density is available.

 Relative Density at 60 F is unknown

Reference Temperature is 60 F

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English

Toptech Systems MultiLoad II User Manual

Table of Contents

Questions and Answers:

Toptech Systems MultiLoad II Specifications

Related product manuals