Chapter 9 – Weights & Measures
Firmware Version 3/4.31.37
2. If the observed temperature is different from the unadjusted temperature displayed, there are two options:
- Press 1 and key in the observed offset (that is, the difference between the Temp Unadjusted and Temp
Adjusted).
- Or, press 2 and key in the observed temperature in the Temp Adjusted field, in which case the Temp
Offset will automatically be calculated and displayed.
Use the +/- key to toggle between a minus (–) sign and a plus (+) sign on the offset.
The temperature offset cannot exceed + or – 3 degrees. If you enter a value greater than 3 in this field, the
value will change to 3, and the temperature will be adjusted by no more than + or – 3 degrees. Likewise, if you
enter an observed temperature that exceeds the Temp Unadjusted value by 3 degrees, the offset will only
change by 3 degrees.
PRE #1 MTR #1 TEMPERATURE
Temperature Unadjusted: +42.27C
[1]Temperature Offset: +0.00C
[2]Temperature Adjusted: +42.27C
Status Ok
Next Prev Exit
PRE #1 MTR #1 TEMPERATURE
Temperature Unadjusted: +42.27C
[1]Temperature Offset: +█ C
[2]Temperature Adjusted: +42.27C
Status Ok
+/- Enter Exit
To Next Page
Loading...
Need help?
General
