Xerox WORKCENTRE 3210

I – 2 WorkCentre 3210/3220 Multifunction Printer Service Manual
Drive Unit Assembly, 2-13
main motor, 2-13
main motor locked error, 3-8
operation, 2-13
part number, 9-5
removal, 8-98
wiring, 10-16
Drum Cleaning Page, 5-38
DTMF Level, 4-5
Duplex Actuator
removal, 8-84
Duplex Unit, 2-8
drive, 2-13
duplex jam error, 3-15
location, 2-8
operation, 2-8
part number, 9-5
removal, 8-69
E
EDC Mode, 4-2
operation, 4-2
test descriptions, 4-2
tests, 4-2
Electrostatic Discharge, 1-vi
Error Rate, 4-5
Errors
abbreviations, 3-5
fax, 3-7
fuser, 3-7
jam, 3-6
laser unit, 3-7
list, 3-6
networking, 3-7
print cartridge, 3-6
tray and media, 3-6
usb, 3-8
Ethernet
port location, 1-5
wiring, 10-19
Exit Actuator
part number, 9-31
removal, 8-92
Exit Idle Gear
part number, 9-13
removal, 8-77
Exit Roller
part number, 9-13
removal, 8-81
Exit Sensor, 2-27
part number, 9-31
removal, 8-93
wiring, 10-17
Exit Sensor Actuator
location, 2-27
F
Fan
laser unit
location, 10-6
removal, 8-111
wiring, 10-16
main
location, 10-6
removal, 8-110
wiring, 10-16
power supply
location, 10-6
wiring, 10-16
types, 2-28
Fasteners, 8-5
precautions, 8-5
Fax, 2-29
common commands, 4-21
errors, 3-7
extension output, 1-5
line input, 1-5
modem test, 4-7
no dial tone, 4-22
parameters, 4-5
part number, 9-5
removal, 8-106
specifications, 1-16
status messages, 3-37
troubleshooting, 4-20
wiring, 10-18
Feed Actuator
removal, 8-82
Feed Gear
part number, 9-13
removal, 8-78
Feed Pad Assembly, 2-8
part number, 9-29
Feed Roller, 2-7
operation, 2-7
part number, 9-14
removal, 8-90
Feed Sensor, 2-27
removal, 8-86
Firmware update, 1-23
network connection, 7-8
Firmware upgrade, 7-7
Fonts
supported, 1-3
Front Cover, 1-4
interlock switch, 2-28
part number, 9-5
removal, 8-58