9980 Self-Propelled Peanut Combine CommandTouch Cornerpost
Automatic Header Height Control System
Platform height adjustment: there are three
modes of adjustment:
• Manual adjust – hydraulic components are
directly activated by the multifunction
control handle.
• Automatic height resume – platform can be
set to any position within the feeder house
range.
• Automatic height sensing – height of the
platform is maintained with
sensor on the right header raise cylinder.
Height Sensing and Active
Header Float Pressure
Sensitivity
(Automatic Functions)
These functions control the speed of response
for header movements when in automatic
sensing and automatic float modes.
To set the speed at which the header follows
ground contour:
1.
Press the feeder house rate/sensitivity
adjust button (top photo) twice
; the
sensitivity setting displays on the
CommandCenter display screen (bottom
sketch).
2.
Turn the selection dial (top photo)
clockwise to increase the response rate or
counterclockwise to lower it; the
adjustments display on the screen.
rate/sensitivity
adjust
NOTE! Settings can be adjusted between
0 and 100.
MAN109 09/04/15 115
To Next Page
Loading...