Amadas 9980 - Feeder House Rate;Sensitivity Adjust

9980 Self-Propelled Peanut Combine Operator’s Controls
MAN141.rev1 08/05/16 49
Feeder House
Rate/Sensitivity Adjust
The feeder house rate/sensitivity adjust button
allows you to compensate for uneven ground
and controls the horizontal and vertical
positions of the header. The system
continuously compares the preset position to
the actual position, making adjustments to
keep the header in the selected working
position.
1. Make sure
the road transport disconnect
indicator light is OFF (middle photo).
2.
Select the desired feeder house adjust
setting:
• Press the feeder rate sensitivity adjust
switch (top photo) once
to select
manual raise/lower speed.
• Press the feeder rate sensitivity adjust
button (top photo) twice
to select the
header height sensitivity adjust. The
selection indicator light turns ON
(bottom photo)
, indicating you can
make a change.
3.
Turn the selection dial (bottom photo)
towards the plus (+) symbol to increase the
response rate/sensitivity or towards minus
(-
) symbol to decrease the response
rate/sensitivity.
The CommandCenter
screen displays the operator adjustment
setting.
Feeder house rate/
sensitivity adjust
NOTE! Press the confirm switch to make
the feeder house rate/sensitivity icons
disappear on the CommandCenter.
For more detailed information, refer to
“Automatic Header Height Control System”
in Chapter 5, CommandCenter Display.
Road transport
disconnect
Indicator light
Selection dial
Indicator light