Amadas 9980 - Replacing Filters

Engine Service 9980 Self-Propelled Peanut Combine
Replacing Filters
5. Drain fuel
contaminates and relieve
pressure from the primary fuel/water
separator (top photo) by opening the
drain.
6.
Drain fuel contaminates and relieve
pressure from the secondary fuel filter
(bottom photo) by opening the drain.
7.
Close drain valves and remove the fuel
filters.
8. Install the replacement primary fuel/water
separator filter and secondary fuel filter.
Tighten ¾ turn after seal contacts filter
housing.
9. O
pen fuel shut off at bottom of fuel tank to
allow primary fuel/water separator filter to
fill.
10. Turn key switch ON for 60 secon
ds to
allow fuel pump to prime fuel system.
11. S
tart engine and run 3 to 5 minutes at low
idle.
CAUTION
Filters may be under pressure. Do NOT
remove filters without completing the
following steps.
NOTE! Use a catch pan when draining
fuel and when removing fuel filters.
Drain
NOTE! Use a catch pan when draining
fuel and when removing fuel filters.
IMPORTANT! Do NOT prefill either fuel
filter with fuel.
Lube filter seals with diesel fuel before
installing.
Drain
220 09/04/15 MAN141