Amadas 9980 - Adjusting Brightness of Display; Adjusting Receiver Settings; Setting Default Display

Overhead Control Panel 9980 Self-Propelled Peanut Combine
Setting Default Display
1.
Press and hold DISPL/TM SET button for
at least two seconds until hour digits flash.
2. Press push-
button 6 to change display
default.
After five seconds of inactivity, the selected
default is displayed.
Adjusting Brightness of Display
If the dash dimmer does not control the
brightness of the receiver display:
1.
Press and hold the DIM button (C) until
“DIM” and the brightness level appear on
the display.
2.
Rotate the AUDIO knob clockwise to
increase the br
ightness of the receiver
display and counterclockwise to decrease
it.
Adjusting Receiver Settings
To adjust Volume, Bass, Treble, Fade, and
Balance, press and release the ON/AUDIO
knob repeatedly until the desired feature
displays.
Volume: Volume is the default function.
Rotate the AUDIO knob clockwise to increase
volume and counterclockwise to decrease it.
The display shows “VOL” and the volume
level.
Bass:
Press AUDIO knob until “BASS” and
present level appear on display. Rotate knob
clockwise t
o increase bass sound and
counterclockwise to decrease it.
Treble: Press AUDIO knob until “TREB” and
present level appear on the display. Rotate
the knob clockwise to increase treble sound
and counterclockwise to decrease it.
Fade: Press AUDIO knob un
til “FADE” and
present level appear on display. Rotate knob
clockwise to move sound to front speakers
and counterclockwise to move sound to rear
speakers.
Balance: Press AUDIO knob until “BAL” and
present level appear. Rotate knob clockwise
to move sound to right speakers and
counterclockwise to move sound to left
speakers. After five seconds of inactivity, the
receiver will return to the default display.
72 09/04/15 MAN141