Lubrication and Maintenance 9980 Self-Propelled Peanut Combine
400 Hours or Yearly, Continued
Check the brake fluid by looking through
the cap. Add brake fluid to 6mm (1/4 “)
from the top. Do NOT let dirt get into
brake fluid.
Lube the elevator and header pump drive
sheave.
Change the hydrostatic charge
filter. Coat the seal on the new
filter with oil. Hand tighten, then
tighten ½ turn more.
Lube the final drive outer bearings on both
sides. When operating in mud and water,
grease every ten (10) hours.
Change the main hydraulic/hydrostatic
filter. It is not necessary to drain the
reservoir
to change this filter. (Part
#AH128449).
Perform battery maintenance:
a.
Clean off top of batteries and check
levels in each cell.
b.
Clean and tighten connections, if
needed.
c. Wipe batteries with damp cloth. When
finished, destroy the cloth.
330 09/08/15 MAN141
To Next Page
Loading...