9980 Self-Propelled Peanut Combine Overhead Control Panel
Communications/CB Radio Mounting
1. Use the dimensions provided (A) and (B)
to locate bracket (C) behind the interior
panel.
A – 185 mm (7.25 in)
B – 225 mm (9 in)
2.
Using the bracket supplied by the radio
manufacturer as a template, drill holes as
required through the foam and plate on
the right-hand rear inside cab.
3. Use self-
tapping screws to mount the
bracket.
4. Remove the right-
and plug (E).
5.
Obtain a rubber grommet from
AMADAS/
John Deere dealer and cut the
grommet so the
antenna cable can be
routed through grommet and cab wall
plate.
NOTE! Do NOT leave the grommet out or
mice can enter the cab area through this
hole.
MAN141 09/04/15 81
To Next Page
Loading...