71 - Maintenance Procedures
F. Repair the engine wiring harness E4A(B)-95-000-000
The following harness repair procedures for connectors replacement can be done only
once for each connector.
If a connector was damaged, without any damage to the cable, it is possible to replace only the
connector housing.
If a connector or a cable branch listed in Table 71 - 1 is defective, the engine harness must be
fully replaced.
Table 71 - 1 Connectors/Cable Branches that cannot be repaired
*) Only replacement of GPC connector housing is permitted. Refer to Paragraph G Step g).
To Next Page
Loading...
