Austro Engine E4 Series - Page 287

E4 Series
Maintenance Manual
Power Plant
E4.08.04
Rev. 29
Page 301
71 -Maintenance Procedures
01-Jul-2020
Detail Steps/Work Items
Key Items/References
(4)
Put the blue isolation of the inline
crimp (Part Number D-436-37) over
the single wire of the repair kit
cable.
Put the splice crimp at the end of
the single wire of the repair kit
cable.
Connect the crimp with the repair
kit cable. Use the crimp tool Mil
Standard Part Number:
M22520/37-01.
(5)
Connect the repair kit cable and
the remaining engine harness.
Use the crimp tool Mil Standard
Part Number: M22520/37-01.
(6)
Put the isolation sleeve of the inline
crimp D-436-37 directly over the
splice crimp.
Apply heat to the inline crimp
isolation until it seals the inline
crimp barrel and the single wires.
Use a hot air gun (300°C – 350°C).
(7)
Put the green Roundit 2000NX5-5
from the repair kit over the inline
crimp and the black expando of the
repair kit cable, if necessary.
Do not do this step if the green
Roundit of the remaining harness is
Crimp
Gasket
Repair kit cable
Remaining
engine harness
Isolation sleeve
Roundit
Expando
Pigtail