71 - Maintenance Procedures
Remove the white cable insulation
down to the shielding of the cable.
Put the solder sleeve over the
cable of the remaining engine
harness.
Apply heat to the solder sleeve.
Use a hot air gun (300°C – 350°C).
Remove the insulation with
shielding of the remaining wire.
Put the blue isolation sleeve of the
inline crimp D-436-37 over the
single wire of the engine harness.
Put the splice crimp at the end of
the single wires of the repair kit
cable E4A-90-R22-000-000.
Use the inline crimp to connect the
single wire of the remaining engine
harness and the white single wire
of the repair kit cable E4A-90-R22-
000-000.
Repair kit cable
single wire
To Next Page
Loading...
