71 -Maintenance Procedures
Put the isolation sleeve of the
inline crimp D-436-37 directly over
the splice crimp.
Apply heat to the inline crimp
isolation sleeve until it seals the
inline crimp barrel and the single
wires.
Use a hot air gun (300°C – 350°C).
Put the chafing protection Roundit
2000NX5-5 over the repair kit
cable and the engine harness.
Decrease the length of the Roundit
2000NX5-5, if necessary.
Make sure that the pigtail comes
out of the Roundit.
Do a check of the connection
between pins. Use a Multimeter.
Attach the repair kit cable E4A-90-
R22-000-000 with the cable ties
PLT1M-M30 and PLT4S-M30.
To Next Page
Loading...
