Austro Engine E4 Series - Page 293

E4 Series
Maintenance Manual
Power Plant
E4.08.04
Rev. 29
Page 307
71 -Maintenance Procedures
01-Jul-2020
Detail Steps/Work Items
Key Items/References
(3)
Remove approx. 50 mm of black
isolation from the remaining
harness.
(4)
Remove the white cable isolation
down to the cable shielding.
(5)
Put the solder sleeve over the
cable of the remaining engine
harness.
Apply heat to the solder sleeve.
Use a hot air gun (300°C – 350°C).
(6)
Remove the white cable insulation
at the end of the remaining engine
harness.
50 mm
(+5)
50 mm (+5)
10 mm (+5)
Pigtail Direction
Solder Sleeve