Error Code
485
Problem Solving
16
027-753
O [Cause] 1. Attempted to execute the service when the port
necessary for the job flow is either deactivated or
disabled.
2. Attempted to execute the job flow to send e-mail with
encryption or a digital signature when the S/MIME
communication is set to disabled.
[Remedy] 1. Have your System Administrator check the port status.
2. Enable the S/MIME communication, or change the job
flow setting so that it can send e-mail without
encryption or a digital signature.
027-796
O O O [Cause] The received e-mail was discarded because it had no
attached documents. (The machine is set to print
attached documents only.)
[Remedy] To print the mail body or header information as well,
change the settings on the Properties screen of
CentreWare Internet Services.
Refer to "E-mail Printing" (P.225).
027-797
O O [Cause] The output destination of the received e-mail is invalid.
[Remedy] Specify a correct output destination, and send the e-mail
again.
033-363
O [Cause] An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
033-710
O [Cause] The document to be sent by polling was deleted.
[Remedy] Store the document again.
033-712
O [Cause] Unable to process due to insufficient memory.
[Remedy] Remove unnecessary data.
033-713
O [Cause] An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
033-716
O [Cause] The mailbox specified from the sender's machine does
not exist.
[Remedy] Register the mailbox.
Refer to "Mailbox" (P.336).
033-717
O [Cause] The mailbox password specified from the sender's
machine is incorrect. Or, the machine password is
incorrect.
[Remedy] Notify the correct password to the sender's machine.
033-718
O [Cause] The mailbox specified by the sender's machine stores no
fax documents, or no polling documents.
[Remedy] Store fax or polling documents into the mailbox as
necessary.
033-719
O [Cause] The document may be deleted by power-cycling the
machine.
[Remedy] Retry sending.
033-721
O [Cause] An error occurred during fax transmission.
[Remedy] Power-cycle the machine. If the machine is not improved
by performing the relevant remedy, contact our Customer
Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
To Next Page
Loading...
