▶
"Removing the fan cage" on page 74.
▶
Release all HDD modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD module" on page
149.
CAUTION
The HDD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶
Release all dummy modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD dummy module" on page
146.
Removing the defective 10x 3.5-inch HDD backplane
▶
If applicable, remove the internal RAID riser module, see "Removing the
internal RAID riser module" on page
273.
▶
Disconnect all cables from the HDD backplane.
Figure 63: Removing the 10x 3.5-inch HDD backplane
▶
Release the eight screws (see circles).
▶
T
ake out the HDD backplane at a slight angle.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M6 Upgrade and Maintenance Manual 153
To Next Page
Loading...
