â–¶
If applicable, remove the OCP module, see "Removing an OCP module" on
page 252.
â–¶
"Getting access to the component" on page 56
.
â–¶
Remove all riser modules, see "Removing a riser module" on page 70.
â–¶
"Removing the air duct" on page 78.
â–¶
"Removing the fan cage" on page 74.
â–¶
"Removing the cross bar" on page 80.
Removing BitLocker protection and decrypting the volume
â–¶
Before removing the TPM board, it is necessary to remove BitLocker
protection from the computer and to decrypt the volume. Ask the system
administrator to turn off BitLocker protection using the BitLocker setup
wizard available either from the Control Panel or Windows Explorer:
â–¶
Open Bitlocker Drive Encryption by clicking the Start button, clicking
Control Panel, clicking Security, and then clicking Bitlocker Drive
Encryption.
Administrator permission required: If you are prompted for an
administrator password or confirmation, type the password or
provide confirmation.
â–¶
T
o turn of
f BitLocker and decrypt the volume, click Turn Off BitLocker,
and then click Decrypt the volume.
Decrypting the volume may be time-consuming. By decrypting the
volume, all of the information stored on that computer is decrypted.
For more information on how to disable BitLocker drive encryption,
see the Microsoft Knowledge Base. See the Fujitsu web pages for
more details.
Disabling the TPM in the system board BIOS
â–¶
Switch on or restart your server.
â–¶
As soon as the startup screen appears, press the
[F2] function key to enter
the BIOS setup menu.
System board and components
RX2540 M6 Upgrade and Maintenance Manual 485
To Next Page
Loading...
Need help?
General
