▶
Select the Configuration menu.
▶
Select the Security Configuration submenu.
▶
Set the TPM Support setting to Disabled.
▶
Save your changes and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
Removing the TPM
▶
Remove the system board, see "Removing the defective system board" on
page 524.
▶
Lay the system board on a soft, antistatic surface with its component side
facing down.
Figure 342: Removing the TPM screw
System board and components
486 Upgrade and Maintenance Manual RX2540 M6
To Next Page
Loading...
