Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

17.2.3 Server rear
17.2.3.1 Connectors on the server rear
Figure 385: Connectors on the server rear
1 VGA connector
2
Serial interface connector
3
Shared LAN connector (LAN1)
4 Management LAN connector
5 USB 3.0 connectors (2x)
The serial interface connector (2) can be used as the standard interface
or for communication with iRMC. The serial interface connector is an
option.
The first left connector of OCP module can be used as Shared LAN
connector (3). OCP modules are options and available in different
variants.
Depending on the BIOS settings, the shared LAN connector may also
be used as a management LAN connector. For more information, see
the corresponding BIOS Setup Utility reference manual.
Some of the devices connected require special software (e.g. drivers)
(see documentation for the connected device).
Liquid cooling configuration
A LC configuration is provided on special release request only.
Appendix A
RX2540 M6 Upgrade and Maintenance Manual 559

Fujitsu PRIMERGY RX2540 M6 Specifications

General

Memory Slots	32 DIMM slots
Form Factor	2U rack server
Processor	Intel Xeon Scalable Processors (3rd generation)
Storage	Up to 24 x 2.5" or 12 x 3.5" drives
RAID Support	RAID 0, 1, 5, 6, 10
Network	4 x 1GbE ports (onboard), optional 10/25GbE
Power Supply	800 W, 1200 W, 1600 W
Expansion Slots	Up to 8x PCIe Gen4 slots
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Management	iRMC S5