RX300 S8
Upgrade and Maintenance Manual 109
Power supply units
6.3.3 Installing a dummy cover
Figure 20: Installing a dummy cover
Ê Insert the dummy cover into the empty bay with the impressed arrow symbol
facing up.
Ê Press in on both release latches on the dummy cover (1) and carefully insert
the dummy cover into its bay (2) until it locks in place.
V CAUTION!
Always install dummy covers into unused bay ts to comply with
applicable EMC regulations and satisfy cooling requirements.
6.3.4 Concluding steps
Ê "Connecting the server to the power source" on page 69
To Next Page
Loading...
