RX300 S8
Upgrade and Maintenance Manual 205
Expansion cards and backup units
Ê If applicable, remove SFP+ transceiver modules from the Modular LAN
controller, as described in section "Removing an SFP+ transceiver module"
on page 238.
Ê Remove the screw (1).
Ê Disconnect the NCSI sideband cable from the system board (2).
Ê Carefully pull up on the Modular LAN controller in a vertical motion and
remove it from its slot (3).
Ê "Installing a PCI slot bracket" on page 187
9.5.3.3 Concluding steps
Ê "Reassembling" on page 63
Ê "Connecting the server to the power source" on page 69.
Ê "Switching on the server" on page 71.
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 85.
Ê "Enabling SVOM boot watchdog functionality" on page 89.
Ê "Enabling BitLocker functionality" on page 95.
Ê If applicable, "After replacing / upgrading LAN controllers" on page 99.
To Next Page
Loading...
