RX300 S8
Upgrade and Maintenance Manual 129
Hard disk drives / solid state drives
7.2.4.3 Installing a 3.5-inch dummy module
V CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD bay to comply with applicable
EMC regulations and satisfy cooling requirements.
Figure 37: Installing a 3.5-inch dummy module
Ê Slide the 3.5-inch dummy module into the drive bay until it locks in place.
7.2.4.4 Concluding steps
Ê "Performing a RAID array rebuild" on page 96
To Next Page
Loading...
