RX300 S8
Upgrade and Maintenance Manual 207
Expansion cards and backup units
9.5.4.3 Installing the Modular LAN controller
Ê If applicable, install a slot bracket on the new Modular LAN controller as
described in section "Installing a slot bracket to the Network adapter D2755"
on page 178.
Ê Install the new Modular LAN controller as described in section "Installing the
Modular LAN controller" on page 197.
Ê If applicable, reinstall SFP+ transceiver modules on the new Modular LAN
controller, as described in section "Installing SFP+ transceiver modules" on
page 234.
9.5.4.4 Concluding steps
Ê "Reassembling" on page 63
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 69.
Ê "Switching on the server" on page 71.
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 85.
Ê "Enabling BitLocker functionality" on page 95.
Ê "Enabling SVOM boot watchdog functionality" on page 89.
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I Configuration of network settings should be performed by the
customer.
For further information, please refer to section "Note on network
settings recovery" on page 206.
Ê If applicable, "After replacing / upgrading LAN controllers" on page 99.
To Next Page
Loading...
