148 Upgrade and Maintenance Manual
RX300 S8
Hard disk drives / solid state drives
7.4.1.4 Concluding steps
Ê "Installing the fan box" on page 164
Ê "Reassembling" on page 63
Ê Reinstall all HDD / SSD modules to their original drive bays as described in
section "Installing 3.5-inch HDD modules" on page 124.
Ê "Connecting the server to the power source" on page 69
Ê "Switching on the server" on page 71
Ê "Enabling BitLocker functionality" on page 95
7.4.2 Replacing the 4x 2.5-inch HDD SAS backplane
7.4.2.1 Preliminary steps
Ê "Locating the defective server" on page 51
Ê "Disabling BitLocker functionality" on page 73
Ê "Shutting down the server" on page 54
Ê "Disconnecting power cords" on page 54
Ê Remove all HDD / SSD modules from the server as described in section
"Removing 2.5-inch HDD / SSD modules" on page 138.
V CAUTION!
Ensure that all hard disk drives are uniquely identified so that you can
reinsert them into their original bays after replacing the HDD
backplane.
Ê "Getting access to the component" on page 57
Ê "Removing the front cover" on page 443
Ê "Removing the fan box" on page 162
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
