Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

434 Upgrade and Maintenance Manual RX300 S8
System board and components
14.6.2 Removing the defective system board
Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see section "Removing processor heat sinks" on page 291
I Leave the processor on the defective board for now.
– Memory modules: see section "Removing memory modules" on
page 256
I Ensure to take note of the memory modules’ mounting positions
for reassembly.
– Expansion cards: see section "Removing expansion cards" on page 185
I Ensure to take note of the controllers’ mounting positions and
cable connections for reassembly.
– UFM: see section "Removing the UFM" on page 406
– onboard SAS enabling key: see section "Removing the onboard SAS
enabling key" on page 428
– SAS RAID controller: see section "Removing the SAS RAID controller"
on page 193

Fujitsu PRIMERGY RX300 S8 Specifications

General

Memory	Up to 768 GB DDR3
Form Factor	2U rack server
Remote Management	iRMC S4 (Integrated Remote Management Controller)
Chipset	Intel C602
Processor	Intel Xeon E5-2600 v2 product family
Storage	Up to 16 x 2.5" or 8 x 3.5" drives
RAID	RAID 0, 1, 5, 6, 10, 50, 60
Network	4 x Gigabit Ethernet ports
Expansion Slots	6 x PCIe 3.0 slots
Operating System Support	Windows Server, Red Hat, SUSE, VMware
Memory Type	DDR3 RDIMM/LRDIMM
Power Supply	Hot-plug redundant power supply units