Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

272 Upgrade and Maintenance Manual RX300 S8
Processors
Figure 146: Closing socket release lever 1
Ê Close the socket release lever marked Open 1st (1) and latch it under the
load plate retention tab (2).
Ê If applicable, install the second processor accordingly.
11.2.3 Concluding steps
Ê "Installing processor heat sinks" on page 286
Ê "Reassembling" on page 63
Ê "Connecting the server to the power source" on page 69
Ê "Updating or recovering the system board BIOS and iRMC" on page 80
Ê "Switching on the server" on page 71
Ê "Enabling SVOM boot watchdog functionality" on page 89
Ê "Enabling BitLocker functionality" on page 95

Fujitsu PRIMERGY RX300 S8 Specifications

General

Memory	Up to 768 GB DDR3
Form Factor	2U rack server
Remote Management	iRMC S4 (Integrated Remote Management Controller)
Chipset	Intel C602
Processor	Intel Xeon E5-2600 v2 product family
Storage	Up to 16 x 2.5" or 8 x 3.5" drives
RAID	RAID 0, 1, 5, 6, 10, 50, 60
Network	4 x Gigabit Ethernet ports
Expansion Slots	6 x PCIe 3.0 slots
Operating System Support	Windows Server, Red Hat, SUSE, VMware
Memory Type	DDR3 RDIMM/LRDIMM
Power Supply	Hot-plug redundant power supply units