RX300 S8
Upgrade and Maintenance Manual 61
Basic hardware procedures
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY RX300 S8 server must not run while the housing cover
is removed.
●
For further safety information, please refer to chapter "Important
information" on page 39.
4.4.3.1 Removing the housing cover
Figure 6: Removing the housing cover
Ê Open the locking lever (1). This will slide the top cover back disengaging the
locking mechanism (2).
Ê Remove the top cover (3).
To Next Page
Loading...
