412 Upgrade and Maintenance Manual
RX300 S8
System board and components
14.3.3.4 Concluding steps
Ê "Installing the air duct" on page 63
Ê "Mounting the housing cover" on page 65
Ê "Sliding the server into the rack" on page 68
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 65.
Ê "Connecting the server to the power source" on page 69
Ê "Enabling SVOM boot watchdog functionality" on page 89
Ê "Enabling BitLocker functionality" on page 95
14.3.3.5 Software configuration
The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.
To Next Page
Loading...
