64 Upgrade and Maintenance Manual
RX300 S8
Basic hardware procedures
Figure 9: Installing the air duct
Ê Insert the air duct first with the rear side (1).
I If there is a BBU or FBU installed, follow the procedure that is
described in section "Installing the air duct with a BBU" on page 213
or in section "Installing the air duct with an FBU" on page 226.
4.5.2 Closing the server
V CAUTION!
●
Before attaching the covers, make sure no unnecessary parts or tools
are left inside the server.
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY RX300 S8 server must not run while the housing cover
is removed.
●
For further safety information, please refer to chapter "Important
information" on page 39.
To Next Page
Loading...
