438 Upgrade and Maintenance Manual
RX300 S8
System board and components
14.6.3.2 Swapping processors
Preparing the processor socket load plates on the new system board
Ê "Removing the protective socket cover" on page 269
Removing processors from the defective system board
Ê Carefully remove the processors from their sockets on the defective system
board as described in "Removing the processor" on page 278.
V Remove and reinstall one processor at a time. Do not remove the
second processor from the defective system board until the first
processor has been installed on the new system board.
Installing processors on the new system board
Ê "Installing the new processor" on page 268.
Installing protective socket covers on the defective system board
I Since the defective system board is sent back for repair, protect the
delicate processor socket springs with a socket cover.
Ê "Installing the protective cover" on page 280
To Next Page
Loading...
