Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

RX300 S8 Upgrade and Maintenance Manual 201
Expansion cards and backup units
Figure 97: Fasten the Modular LAN controller
Ê Fasten the Modular LAN controller with a screw.
Ê If applicable, install SFP+ transceiver modules into the Modular LAN
controller, as described in section "Installing SFP+ transceiver modules" on
page 234.
9.5.2.4 Connecting the NCSI sideband cable to the system board
I Connecting the NSCI sideband cable is only necessary in order to use
the Modular LAN controller as a shared LAN interface, that allows both,
management and dedicated LAN connections.
If the Modular LAN controller is to be used for dedicated network
connections only, please skip this section.

Fujitsu PRIMERGY RX300 S8 Specifications

General

Memory	Up to 768 GB DDR3
Form Factor	2U rack server
Remote Management	iRMC S4 (Integrated Remote Management Controller)
Chipset	Intel C602
Processor	Intel Xeon E5-2600 v2 product family
Storage	Up to 16 x 2.5" or 8 x 3.5" drives
RAID	RAID 0, 1, 5, 6, 10, 50, 60
Network	4 x Gigabit Ethernet ports
Expansion Slots	6 x PCIe 3.0 slots
Operating System Support	Windows Server, Red Hat, SUSE, VMware
Memory Type	DDR3 RDIMM/LRDIMM
Power Supply	Hot-plug redundant power supply units