RX300 S8
Upgrade and Maintenance Manual 189
Expansion cards and backup units
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Removing the slot bracket" on
page 182.
9.3.3.3 Installing an expansion card
Ê If applicable, "Installing a slot bracket" on page 172.
Ê "Installing expansion cards" on page 182.
Ê If applicable, "Installing SFP+ transceiver modules" on page 234.
9.3.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "List of used
cables" on page 465.
9.3.3.5 Connecting a battery backup unit to the expansion card
Ê If applicable, connect a BBU or FBU to the expansion card as described in
sections "Installing a BBU" on page 209or "Installing a FBU" on page 221.
9.3.3.6 Concluding steps
Ê "Reassembling" on page 63
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 69
Ê "Switching on the server" on page 71
Ê "Enabling replaced components in the system BIOS" on page 89
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 96.
Ê "Updating RAID controller firmware" on page 84
Ê "Enabling SVOM boot watchdog functionality" on page 89
Ê "Enabling BitLocker functionality" on page 95
To Next Page
Loading...
