Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

RX300 S8 Upgrade and Maintenance Manual 327
Accessible drives
12.10 Replacing the tape/RDX drive in 3.5-inch
version
12.10.1 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 73
Ê "Locating the defective server" on page 51
Ê "Removing backup and optical disk media" on page 76
Ê "Verifying and configuring the backup software solution" on page 77
Ê "Shutting down the server" on page 54
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 57
Ê "Removing the fan box" on page 162
12.10.2 Removing the defective tape/RDX drive
Ê "Removing the drive cage" on page 324
Ê "Removing a tape/RDX drive out of the cage" on page 325
12.10.3 Installing the new tape/RDX drive
Ê "Installing a tape/RDX drive in the cage" on page 317
Ê "Installing the tape/RDX drive" on page 319
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver

Fujitsu PRIMERGY RX300 S8 Specifications

General

Memory	Up to 768 GB DDR3
Form Factor	2U rack server
Remote Management	iRMC S4 (Integrated Remote Management Controller)
Chipset	Intel C602
Processor	Intel Xeon E5-2600 v2 product family
Storage	Up to 16 x 2.5" or 8 x 3.5" drives
RAID	RAID 0, 1, 5, 6, 10, 50, 60
Network	4 x Gigabit Ethernet ports
Expansion Slots	6 x PCIe 3.0 slots
Operating System Support	Windows Server, Red Hat, SUSE, VMware
Memory Type	DDR3 RDIMM/LRDIMM
Power Supply	Hot-plug redundant power supply units