440 Upgrade and Maintenance Manual
RX300 S8
System board and components
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 96.
Ê After replacing the system board in a server running Linux OS, "Updating the
NIC configuration file in a Linux environment" on page 93
Ê "Enabling SVOM boot watchdog functionality" on page 89
Ê "Enabling BitLocker functionality" on page 95
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I Configuration of network settings should be performed by the
customer.
For further information, please refer to section "Note on network
settings recovery" on page 432.
Ê If applicable, "After replacing the system board" on page 99.
To Next Page
Loading...
