SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Fault Messages Chapter 7 page 395
20
Problem: This means that the main motor is in reverse without TWO HAND INCH
mode selected.
Remedy: Set SmartPAC to TWO HAND using the Mode Select menu and set the
STROKE SELECT SWITCH TO INCH. Then run the motor in reverse.
If you need assistance in making the "Two Hand" setting, refer to Chapter
6 of this manual.
22
Problem: This means that the operating mode was changed with the press running.
Remedy: Reset. Run the press after you have made the operating mode selection.
Consult Chapter 6 for the correct operating mode to select.
23
Problem: This means that the operating mode you selected is not a valid one.
Remedy: Reset. Consult Chapter 6 to determine the correct operating mode to
select.
24
Problem: This means that both palm buttons were pressed while in One Hand mode.
Remedy: After clearing the error, run the press pressing only one button.
To Next Page
Loading...
Need help?
General
