Lexmark 7462 series - Page 152

Error code Description Action
28y.40 The sensor (left tamper HP) does not detect that the
tamper has moved from home position.
Go to
“Left tamper does not leave home
position failure (StapleSmart finisher) service
check” on page 159.
28y.41 The sensor (left tamper HP) does not detect that the
tamper has reached home position.
28y.42 The sensor (right tamper HP) does not detect that
the tamper has moved from home position.
Go to
“Right tamper does not leave home
position failure (StapleSmart finisher) service
check” on page 160.
28y.43 The sensor (right tamper HP) does not detect that
the tamper has reached home position.
28y.44 The sensor (eject HP) does not detect that the eject
mechanism is operating.
Go to
“Sensor (StapleSmart finisher eject HP)
service check” on page 155.
28y.45 The sensor (eject HP) does not detect the home
position upon completion of normal media eject
operation.
28y.46 The sensor (paddle HP) does not detect that the
paddle is operating.
Go to
“Paddle home position jam service
check” on page 160.
28y.47 The sensor (paddle HP) does not detect the home
position upon completion of normal paddle
operation.
28y.48 The sensor (deflector gate HP) does not detect
transition of the deflector gate to the output option.
Go to
“Deflector gate transition to output
option not detected service check” on
page 163.
28y.49 The sensor (deflector gate HP) does not detect
transition of the deflector gate to the standard bin.
Go to
“Deflector gate transition to standard bin
not detected service check” on page 163.
28y.50 The left tamper home position is not detected by
the sensor (left tamper HP).
Go to
“Left tamper home position (StapleSmart
finisher) jam service check” on page 161.
28y.51 The right tamper home position is not detected by
the sensor (right tamper HP).
Go to
“Right tamper home position
(StapleSmart finisher) jam service check” on
page 161.
28y.52 A software error has occurred with the output
option (paddle control motor timer error).
Go to
“StapleSmart finisher software error
service check” on page 154.
28y.53 The eject motor is not detected upon startup. Go to
“Motor (StapleSmart finisher eject)
service check” on page 154.
28y.54 The eject motor encoder detection is lost during
normal operation.
Go to
“Motor (StapleSmart finisher eject)
service check” on page 154.
28y.55 The eject motor rotate at the specified speed
(overspeed failure).
Go to
“Motor (StapleSmart finisher eject)
service check” on page 154.
28y.56 The eject motor rotate at the specified speed
(underspeed failure).
Go to
“Motor (StapleSmart finisher eject)
service check” on page 154.
28y.57 Media remains on the sensor (stapler pass through)
during the warm up sequence.
Go to
“Sensor (stapler pass through) static jam
service check” on page 157.
28y.58 The media is late reaching the sensor (stapler pass
through) within the specified time.
Go to
“Sensor (stapler pass through) late jam
service check” on page 156.
7462
Diagnostic information
152