NTP-005: Operation 365-575-102
Page2of2 Issue8.0,July2002
Operation: NTP-005---+---DLP-529
|---DLP-501
3. Verify that there are no active alarms or status
conditions by selecting the
FAULT-Retrieve-Alarms (and
Status):All or by pressing function key F9.
Review the Active Alarms and Status Report
and clear any conditions before starting this
procedure.
—
4. At the CIT, select
CONFIGURATION-Retrieve-Map-Network
command to obtain the Network Map Report or
select CONFIGURATION-Retrieve-Map
Ring commandtoobtaintheRingMapReport
for release 5. An example of these reports with
a description of the output parameters is
provided in Section 11 of this manual.
—
5.
NOTE:
The software in the network will be updated by starting with the
topmost FT-2000 network element (TID) in the report (except the
DS-NE) and moving down the list of TIDs (nodes) one at a time. This
approach updates the network software in an East direction on a
section-by-section basis and ends with the DS-NE.
Refer to the appropriate software release
description for your particular release and
perform the Remote (DCC) Download pro-
cedure. The software release descriptions
are listed in "Operation: NTP-002".
—
DOITEMSBELOWINORDERLISTED....... FORDETAILS,GOTO
To Next Page
Loading...
Need help?
General