NTP-010: Operation 365-575-102
Page4of4 Issue8.0,July2002
Operation: NTP-010---+---TAP-102
+---DLP-501
16. Verify that there are no active alarms or status
conditions by selecting the
FAULT-Retrieve-Alarms (and Status):All or by
pressing function key F9. Review the Active
Alarms and Status Report and clear any
conditions before continuing with this procedure.
TAP-102
17. Are there additional nodes to be upgraded? —
If NO, then go to Step 19.
If YES, then continue.
As necessary, assign personnel to the next two
nodes to be upgraded (e.g., B and C).
18. Repeat steps 7 through 17, replacing site A with
B and B with C, etc,. Repeat these steps until all
pairs of nodes around the ring have been
completed.
—
19. Now, STS-1 granular add and drop
cross-connections can be established to nodes
in the ring where STS-1 granular optical packs
are installed. This completes the procedure.
—
DOITEMSBELOWINORDERLISTED....... FORDETAILS,GOTO
To Next Page
Loading...