EasyManuals Logo

Lucent Technologies FT-2000 OC-48 User Manual

Lucent Technologies FT-2000 OC-48
1578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1297 background imageLoading...
Page #1297 background image
365-575-102 TroubleClearing:
Issue 8.0, July 2002 Page 1 of 2
TAP-159
Clear ‘CPYPGM:IP (tid)’
NOTE:
This condition means that software (Release 5.0 and later) is being copied from
this FT-2000 network element to the FT-2000 network element whose target
identification (TID) appears in the message.
NOTE:
The software download is performed in the background (approximately 1 hour)
and is from one SYSMEM circuit pack to another SYSMEM circuit pack. Up to
15 downloads can occur simultaneously. See the Software Release Description
Known Problems section for limitations on simultaneous downloads with some
software releases. The first known limitation was with Release 7. The limit is 8
simultaneous copies.
NOTE:
You cannot cancel the background download once it is initiated.
1. If desired, you may perform other CIT-PC activities during this time, for exam-
ple, checking the status of the download [use the CONFIGURA-
TION-Retrieve-Alarm (and Status) command].
If an error message appears on the screen during the background down-
load, reinitiate the software download per Operation: NTP-005.
2. STOP! YOU HAVE COMPLETED THIS PROCEDURE.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies FT-2000 OC-48 and is the answer not in the manual?

Lucent Technologies FT-2000 OC-48 Specifications

General IconGeneral
BrandLucent Technologies
ModelFT-2000 OC-48
CategoryNetwork Hardware
LanguageEnglish