DLP-511: Detailed Level Procedure 365-575-102
Page2of2 Issue8.0,July2002
9. Put a finger in each wire loop and pull the shelf cover forward nearly 3 inches
and lift cover up to free it from the shelf framing.
10. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
Replace Cover
11. Which cover is being replaced?
If Circuit Pack Shelf Cover, then continue with Step 12.
If Interconnection Panel Cover, then continue with Step 13.
12. Position the pivot pins located at the bottom of the cover under the flange on
the shelf framing, then continue with Step 14.
13. Place bottom of cover over side pivot pins.
14. Close the cover and rotate the two 1/4-turn fasteners 90 degrees clockwise
using the screwdriver (or dime) until the fastener slots are horizontal (locked
position).
15. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General