365-575-102 DetailedLevelProcedure:
Issue 8.0, July 2002 Page 1 of 2
DLP-517
Provision Low-Speed Slot and Port Parameters
1. NOTE:
Provisioning information is described in Volume 1, Section 8 of this manual. A
Job Aid is also available for the FT-2000 add/drop-rings terminal
(365-575-122).
Find the slot parameter in Table A to be provisioned or the port parameter in
Table B to be provisioned and use the indicated CIT command(s) to provision
the desired parameter(s):
Table A - Slot Parameters
Slot for Parameter Input (Command)
DS-3 and/or
EC-1
Protection Switching Priority CONFIGURATION-Set-Low Speed
OC-3 Protection Mode (From
OC3)
CONFIGURATION-Set-OC3
Protection Mode (From
OC48)
Alarm Level
Signal Degrade Threshold
Output AU4 Mapping
DCC Assignment CONFIGURATION-Enter-Assignment-DCC
OC-12 Protection Mode (From
OC12)
CONFIGURATION-Set-OC12
Protection Mode (From
OC48)
Alarm Level (Near End)
Alarm Level (Far End)
Signal Degrade Threshold
Output AU4 Mapping
OC12 Timing Direction
Sync Messages
DCC Assignment CONFIGURATION-Enter-Assignment-DCC
To Next Page
Loading...
Need help?
General