DLP-522: Detailed Level Procedure 365-575-102
Page2of4 Issue8.0,July2002
Delete Login
7. At the CIT, select SECURITY-Set-Login-Delete: for the specified user's
login to be deleted and press function key F9 to execute the deletion.
8. At the CIT, select SECURITY-Retrieve-Login: to obtain the Login
Provisioning Report and verify that the user's login has been deleted.
9. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
Enter Login
NOTE:
Each FT-2000 network element may have up to 10 nonprivileged users with
software Releases 4.0 and lower and up to 98 nonprivileged users with
software Releases 4.1 and later.
10. At the CIT, select SECURITY-Set-Login-Enter and enter the new user
login (up to 10 alphanumeric characters) and an initial password (from 6 to 10
characters with 1 number and with 1 symbolic character except the @, #, and
=).
11. When prompted, reenter the initial password to verify your intended password.
Passwords are not displayed.
12. Assign either security level (Reports Only or General) to the user's login and
press function key F9 to execute the assignment.
13. At the CIT, select SECURITY-Retrieve-Login: to obtain the Login
Provisioning Report and verify that the user's login has been entered.
14. The login and initial password may be given to the person working on the
FT-2000 network element.
15. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
Enable/Disable Login Aging and/or Password Aging
16. At the CIT, select the SECURITY-Set-Security-Network Element:
command to gain access to the global security parameters for the system.
17. Select the appropriate input parameter, enter a value, and press function key
F9.
Logins Allowed= <Yes, No> If No, all nonPrivileged users will be imme-
diately disconnected.
Password Aging= <0, 7 through 999> A 0 (zero) will disable.
Login Aging= <0, 7 through 999> A 0 (zero) will disable.
To Next Page
Loading...
Need help?
General