Operations Interfaces
Issue 8.0 July 2002
6-27
RELEASE-LOOPBACK (RLS-LPBK-rr)†—releases low speed (DS3, EC-1, and OC-3)
or high speed (OC-3) loopback
RELEASE-PROTECTION SWITCH-OC3 (RLS-PROTNSW-OC3)* — releases OC-3 line
protection switching
RELEASE-PROTECTION SWITCH-OC12 (RLS-PROTNSW-OC12)§§ — releases OC-12
line protection switching.
RELEASE-PROTECTION SWITCH-OC48 (RLS-PROTNSW-OC48)†—releases OC-48 line
protection switching
RELEASE-PROTECTION SWITCH (RLS-PROTNSW-rr)†—releases STS-3 tributary
protection switching
RELEASE-SYNCHRONIZATION SWITCH (RLS-SYNCNSW)†—releases synchronization
reference protection switching
RETRIEVE-AUTONOMOUS OUTPUT (RTRV-AO)* — retrieves copies of autonomous TL1
messages
RETRIEVE-ALARM (RTRV-ALM) — retrieves active alarm conditions
RETRIEVE-ALARM-NETWORK (RTRV-ALM-NTWK)§§ — retrieves active alarm/or status
conditions for all network elements in the maintenance subnetwork
RETRIEVE-ALARM-ENVIRONMENT (RTRV-ALM-ENV)†—retrieves active environmental
alarm conditions
RETRIEVE-rr (RTRV-rr)†—retrieves current provisioned state of low speed ports and
slots
RETRIEVE-ASSIGNMENT-DCC (RTRV-ASGNMT-DCC)§§ — retrieves information on the
assignment of DCC channels to low-speed slots or slot pairs.
RETRIEVE-ATTRIBUTE ALARM (RTRV-ATTR-ALM)§—retrieves the current values of the
incoming signal alarm delay, alarm clear delay interval, and power minor alarm parameters
RETRIEVE-ATTRIBUTE CONTROL (RTRV-ATTR-CONT)§—retrieves provisioned
description(s) of the external control outputs
RETRIEVE-ATTRIBUTE ENVIRONMENT (RTRV-ATTR-ENV)§—retrieves provisioned
description(s) of the environmental inputs
RETRIEVE-ATTRIBUTE (RTRV-ATTR-rr)* — retrieves the notification code associated
with incoming signal failure events
RETRIEVE-CIRCUIT-PATH (RTRV-CKT-rr)§§ — retrieves a circuit path report showing
all of the cross-connections that make up the circuit.
RETRIEVE-CONDITION (RTRV-COND)†—retrieves all active alarm and status conditions
To Next Page
Loading...