Operations Interfaces
Issue 8.0 July 2002
6-29
RETRIEVE-SYSTEM (RTRV-SYS)†—retrieves network element name and other system
level parameters
RETRIEVE-THRESHOLD (RTRV-TH)§—retrieves the current threshold level of one or
more monitored parameters
RETRIEVE-TIME-SLOT (RTRV-TMSLT)§§ — retrieves the Tributary Map report
RETRIEVE-USER-SECURITY (RTRV-USER-SECU)* — retrieves security parameters
associated with a login
SET-ATTRIBUTE ALARM (SET-ATTR-ALM)§—sets the current values of the incoming
signal alarm delay, alarm clear delay interval, and power minor alarm parameters
SET-ATTRIBUTE CONTROL (SET-ATTR-CONT)§—provisions the description(s) of the
external control outputs
SET-ATTRIBUTE ENVIRONMENT (SET-ATTR-ENV)§—provisions the description(s) of
the environmental inputs
SET-ATTRIBUTE (SET-ATTR-rr)* — sets notification code associated with incoming
signal failure events
SET-PERFORMANCE-MONITORING-START-TIME (SET-PM-STIME)§§ — sets the start
time for the measurement of all 24 hour performance monitoring parameters
SET-SITE ID (SET-SID)* — sets the target identifier (TID) of the network element
SET-THRESHOLD (SET-TH)§—sets the threshold level for monitored parameters
SWITCH-TO PROTECTION (SW-TOPROTN)* — performs an equipment (circuit pack)
protection switch on DS3 and/or STS1E, or TG3 (DS1) circuit packs
SWITCH-TO WORKING (SW-TOWKG)* — resets an equipment (circuit pack) protection
switch on DS3 and/or STS1E, or TG3 (DS1) circuit packs
TEST-AUTO-TURNUP (TEST-AUTO)§§ — tests the system and cabling
TEST-EQUIPMENT (TEST-EQPT)§§ — tests the audible and visual office alarms and the
system LEDs
TEST-TELEMETRY (TEST-TLM)§§ — tests the system's parallel telemetry
UPDATE-SYSTEM (UPD-SYS)* — updates the state of all the automatically provisioned
parameters
* Available in Releases 5 and later.
† Available in Releases 4.1 and later.
‡ Available in Releases 6 and later.
§ Available in Releases 7 and later.
§§ Available in Releases 7.2 and later.
To Next Page
Loading...