About This Document
xxxiv Issue 8.0 July 2002
â– Volume I, Section 11, "Craft Interface Terminal Usage," describes how the
craft interface terminal is used and shows the FT-2000 OC-48 Lightwave
System inputs (commands), output messages, and reports. It also includes
a tutorial on the use of the craft interface terminal.
â– The "Operation and Maintenance (TOP)" contains specific task-oriented
procedures for the acceptance, circuit order, operation, and trouble
clearing of the FT-2000 OC-48 Lightwave System.
Conventions Used
The BOLD font is used throughout this manual for emphasis. The descriptive
sections in this manual use a Courier Bold font to identify menu input
selections to the system. UPPERCASE letters identify letter designations on
panels, shelves, and circuit packs.
The procedures in the "Operation and Maintenance (TOP)" section (Volume II)
use a MONOSPACE font to identify text on a screen or a response displayed from
the system. A BOLD font identifies letter designations on panels, shelves, and
circuit packs.
Safety Instructions
Safety Labels
This manual may contain safety labels in the form of DANGERS, WARNINGS,
and CAUTIONS. These safety labels have the following definitions:
â– DANGER shows the presence of a hazard that
will
cause death or severe
personal injury if the hazard is not avoided.
â– WARNING shows the presence of a hazard that
can
cause death or severe
personal injury if the hazard is not avoided.
â– CAUTION shows the presence of a hazard that
will
or can cause minor
personal injury or property damage if the hazard is not avoided. Caution is
also used for property-damage-only accidents. This includes equipment
damage, loss of software, or service interruption.
These admonishments are noted by the alert symbol .
!
To Next Page
Loading...
Need help?
General