EasyManuals Logo

Lucent Technologies FT-2000 OC-48 User Manual

Lucent Technologies FT-2000 OC-48
1578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #422 background imageLoading...
Page #422 background image
Administration and Provisioning
8-18 Issue 8.0 July 2002
In Release 5 and later releases, a bridge cross-connection is any two
superimposed cross-connections sharing the same source. The source
can be any incoming STS-3 tributary of OC-48 high-speed line 1E or 1W,
or any service low-speed interface slot.
In Release 5 and later releases, cross-connections can be made to/from
any service low-speed interface slot and the companion low-speed
interface slot (for example, 2A and 2B) when the slot pair is provisioned for
the OC-3 1+1 protected mode. For example, Figure 8-3 shows incoming
service STS-3 tributary 6 of OC-48 high-speed line 1E cross-connected to
outgoing service STS-3 tributary 6 of OC-48 high-speed line 1W. Incoming
service STS-3 tributary 6 of OC-48 high-speed line 1W is also
cross-connected to service low-speed interface slots 8A and 8B.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies FT-2000 OC-48 and is the answer not in the manual?

Lucent Technologies FT-2000 OC-48 Specifications

General IconGeneral
BrandLucent Technologies
ModelFT-2000 OC-48
CategoryNetwork Hardware
LanguageEnglish