Administration and Provisioning
Issue 8.0 July 2002
8-69
■ At node 1, a 1-way drop cross-connection is entered by specifying:
— Source (tributary)
— Source line (line 1W)
— Source STS-3 tributary (tributary 6)
— Source node TID
*
(node 0 TID)
— Destination (slot)
— Destination low-speed interface slot (slot 4A).
■ A 1-way through cross-connection is entered by specifying:
— Source (tributary)
— Source line (line 1E)
— Source STS-3 tributary (tributary 6)
— Source node TID* (node 0 TID)
— Destination (tributary)
— Destination node TID* (node 2 TID).
■ At node 2, a 1-way drop cross-connection is entered by specifying:
— Source (tributary)
— Source line (line 1W)
— Source STS-3 tributary (tributary 6)
— Source node TID* (node 0 TID)
— Destination (slot)
— Destination low-speed interface slot (slot 4A).
■ A 1-way-DRI cross-connection is entered by specifying:
— Source low-speed interface slot (slot 4B)
— Destination line (line 1E)
— Destination STS-3 tributary (tributary 6)
— Destination node TID* (node 0 TID).
— Secondary node TID* (node 0 TID).
* In Release 4.1 and later releases, entering a question mark (?) in response to the TID
prompt will display a point-and-shoot list of available addresses in the OC-48 ring. Enter
the Retrieve-Map-Ring command to update the point-and-shoot list.
To Next Page
Loading...